Cutting fluids, hydraulic oils, greases and forklift tyre marks that drip onto the floor in production areas gradually build up into a thick, slippery layer. This layer is one of the main causes of slip and fall accidents, shortens the life of the floor coating and spoils the appearance of the plant.
Approach by floor type
| Floor | Characteristics | Cleaning approach |
|---|---|---|
| Epoxy and polyurethane coating | Non-porous, limited chemical resistance | Low-to-medium alkaline cleaner that does not damage the coating |
| Bare concrete | Porous, absorbs oil deeply | Strong alkaline, penetrating oil remover; dwell time if needed |
| Industrial tiles and ceramics | Grout lines hold dirt | Alkaline cleaner, brush application for grout |
| Dry-shake hardened / power-trowelled concrete | Hard, dense surface | Alkaline cleaner, machine scrubbing |
Points to watch on epoxy floors
- Avoid very high pH and solvents: They can damage the gloss and surface integrity of the coating.
- Choose a residue-free product: A detergent film left on the surface makes the floor slippery and speeds up re-soiling.
- Regular maintenance: Regular cleaning before the dirt builds up reduces the need for aggressive chemicals.
Application methods
- Dry cleaning: Sweep up dust, chips and coarse dirt.
- Chemical application: Dilute the product at the recommended ratio and apply to the floor.
- Dwell time: A few minutes of contact time on heavily oiled areas.
- Mechanical action: Scrub with a floor scrubber or stiff brush.
- Collect the dirty water: With the machine’s vacuum or a squeegee.
- Rinsing: With clean water to prevent residue.
Low-foam products should be used in floor scrubbers; high foam can damage the machine’s vacuum motor.
Wastewater
Water from floor cleaning contains oil and detergent. Before discharge to the sewer it should pass through an oil separator or the plant’s wastewater treatment system and be managed in accordance with local regulations.
Frequently asked questions
Why is the floor still slippery after cleaning?
A detergent film left by insufficient rinsing, or oil that has not been completely removed, causes slipperiness. Correct dilution and rinsing with clean water solve the problem.
Can old oil stains soaked into concrete be removed?
On porous concrete, old stains penetrate deeply. They can be largely lifted with penetrating alkaline oil removers, allowing dwell time and repeating the application a few times; very old stains may not disappear completely.
Support for your floor cleaning
Molkim offers oil and grease removers and machine-compatible floor cleaning chemicals for epoxy, polyurethane and concrete floors. If you share your floor type and type of contamination, we can determine the right product together.
Related products: Floor and Epoxy Floor Cleaning Chemicals · Industrial Hand Cleaning Products · Contact
